Installing The Engine Controller - Barco Galaxy NH-12 Service Manual

7. Electronic parts and servicing procedures
- J1: from the infitec sensor
- J2: from the infitec slide
- J4: Infitec sync from the PMP
- J5: I2C from the PMP
- J7: from the infitec SW
- J10: to the infitec motor
- J30: from DMD temperature switch
- J101: power and pulses from fan LPS vertical
- J102: power and pulses from fan LPS top
- J104: power to the cooling pump
- J110: fan supply to the X-fan supply
- J120: fan pulses towards the power box
- J130: +12V from the power box
- J220: from the lens shift safety switch
- J230: signals from the CLO/LFR sensor
- J400: to the LFR light feedback board
- J402: I2C to the LPS
- J403: data from the lamp info receiver
3. Remove the fixing screws of the engine controller
Image 7-137
Engine controller: fixing screws
4. Remove the engine controller

7.12.3 Installing the engine controller

Necessary tools
Torx screwdriver T10
How to install the engine controller?
1. Put the engine controller in the correct position
2. Fix it using the fixing screws
100 R59770141 GALAXY NH-12 20/02/2008