Lamp Temperature Sensor; Ambient Temperature And Pressure Sensor - Barco Galaxy NH-12 Service Manual

Image 7-167
Local keypad and IR receiver: fixing screws
3. Fix the local keypad and IR receiver assembly to the preformatter unit using two nuts and spacers
Image 7-168
Local keypad and IR receiver assembly: fixing nuts and spacers
Caution: Tighten both nuts and then release them half a revolution. In this way the local keypad can move slightly to fit the
slots in the front cover!
4. Fix the preformatter unit to the projector (see concerning chapter)

7.19 Lamp temperature sensor

Necessary tools
Torx screwdriver T10
How to remove the lamp temperature sensor?
1. to be implemented
How to install the lamp temperature sensor?
1. to be implemented

7.20 Ambient temperature and pressure sensor

Necessary tools
Torx screwdriver T10
How to remove the ambient temperature and pressure sensor?
1. Remove the covers (see concerning chapters):
- rear cover
- front cover
R59770141 GALAXY NH-12 20/02/2008
7. Electronic parts and servicing procedures
113