Removing The Output And Communication Layer - Barco Galaxy NH-12 Service Manual

Schematic overview
TXD
RS232
CTS
DVI
transmitter
Wired IR
R.C.
converter
+ disable
IR
Image 7-88
output and communication layer
7.7.4.3.2

Removing the output and communication layer

Necessary tools
• Torx screwdriver T10
• Nut spanner 3/16"
How to remove the output and communication input layer?
1. Remove the input module (see considering chapter)
2. Remove the front nuts of the output and communication input layer
Image 7-89
output and communication input layer: front screws
3. Remove the side screw, fixing the output and communication input layer to the PMP
R59770141 GALAXY NH-12 20/02/2008
not configured
I2C
config
DVI
FPGA
Output/communication layer
7. Electronic parts and servicing procedures
EID
1
.
.
.
80
1
.
.
LVDS
.
80
79