Mid-Mount Two-Spool Control Valve Lever - New Holland Workmaster 25S Operator's Manual

Mid-mount two-spool control valve lever

The mid mount two-spool control valve (1) location is to
the right-hand side of the instrument panel. The con-
trol valve operates the front-end loader and other front
mounted implements.
The control valve is equipped with a control lever lockout
(2) that locks the control valve handle in the neutral posi-
tion and does not allow the valve to operate.
To operate the control valve, move the control lever (1) in
any of the four directions.
Release the control lever to stop the cylinder in any posi-
tion, the lever automatically returns to neutral.
• Move the control lever forward to lower the loader/re-
tract cylinder (A).
• Move the control lever to the left to curl the bucket/re-
tract cylinder (B).
• Move the control lever rearward to raise the loader/ex-
tend cylinder (C).
• Move the control lever to the right to dump bucket/ex-
tend cylinder (D).
Move the control lever fully forward to "FLOAT" position
(E) which allows the loader boom lift cylinders to extend
or retract. This valve position will allow the loader to fol-
low the ground contour during operation. Float is also a
"dented" position, meaning you must manually return the
control valve lever to the neural position.
NOTE: Do not use the "FLOAT" position (E) if the loader
bucket is off the ground.
3 - CONTROLS AND INSTRUMENTS
3-12
1
NHIL17CT00179AA
2
NHIL17CT01827AA