Sulphur In Fuel; Coolants; Using Plain Water - New Holland T6.140 Service Manual

Sulphur in fuel

The engine oil and filter change period are shown in the Lubrication and Maintenance in the operators manual. How-
ever, locally available fuel may have a high sulphur content, in which case the engine oil and filter change period
should be adjusted as follows:
Sulphur content
Below 5 mg/kg (5 ppm)
From 5 - 10 mg/kg (5-10 ppm)
Above 10 mg/kg (10 ppm)

Coolants

WARNING
Hazardous chemicals!
Chemical agent may be harmful.
-Avoid contact with eyes, and prolonged/repeated skin contact.
-Wear protective goggles when handling.
-Eye contact: Flush with water for 15 minutes. Seek immediate medical assistance.
-Wash skin with soap and water after handling.
-Keep out of reach of children.
Failure to comply could result in death or serious injury.
To reduce the amount of deposits and corrosion, the water used in the cooling system must comply with the following
values.
Total solids
Total hardness
Chloride (cl)
Sulfate (SO4)

Using plain water

If you reside in a country where antifreeze is not available, use clean water premixed with 5 % chemical inhibitor. The
inhibitor is available from your authorized dealer.
Property
Acidity pH
INTRODUCTION
47665870 27/03/2014
20
Oil change period
Normal
Half the normal
One quarter normal
Maximum value
340 mg/kg (340 ppm)
9.5°dH (170 ppm)
40 mg/kg (40 ppm)
100 mg/kg (100 ppm)
5.5 to 9.0
W0370A