2=Zones; 3: Power - Fire-Lite MS-9200UDLS Manual

Operating Instructions
•
•
•
•
•
•
4.23.2 Zones
READ STATUS
Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:
1=SYSTEM POINT

2=ZONES

3=POWER
Read Status Screen #1
From the preceding screens, the control panel operator can view:
•
•
•
•
•
•
4.23.3 Power
Pressing 3 while viewing Read Status Screen #1 will cause the following screens to be displayed:
The following table lists the circuit being measured, possible conditions and their respective
voltage ranges:
146
Pre-Signal Yes/No (for detectors and monitor modules)
Zone Assignments (five maximum)
Chamber Value
Adjective/Noun descriptor
Silenceable Yes/No (for control modules)
MNS Override Enabled/Disabled (for control modules)
ZONES
1=ZONES INSTALLED
2=ZONES ENABLED
3=ZONES DISABLED
Zones Screen #1
Zones Installed - all software zones programmed into the system (99 maximum)
Zones Enabled - all software zones that are enabled
Zones Disabled - all software zones that have been disabled
Special Purpose - on or off programming for Special Purpose Zones 97 reserved for PAS, 98
reserved for Pre-signal and 99 reserved for Two Stage
Zone Type - the Type assigned to each installed zone (default is Alarm)
Zone Message - the Message assigned to each installed zone
POWER
BATTERY 27.21V
24 V RST 25.31
Power Screen #1
Circuit
Battery
24V Resettable
24V Nonresettable
Charger
NAC 1 - NAC 4
1=SPECIAL PURPOSE
2=ZONE TYPE
3=ZONE MESSAGE
POWER
CHARGER 28.36V
NAC 1 -1.49V
NAC 2 -1.49V
Power Screen #2
Condition
Normal Battery (nominal)
Low Battery
No Battery
Normal
Normal
Normal
Normal
Open Circuit
Short Circuit
MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Read Status
ZONES
Zones Screen #2
POWER
NAC 3 -1.49V
NAC 4 -1.49V
Power Screen #3
Voltage Range
27.05 to 28.15 VDC
20.0 to 20.8 VDC
0 to 18.36 VDC
21.25 to 27.50 VDC
21.25 to 27.50 VDC
21.87 to 29.84 VDC
-1.3 to -1.6 VDC
-2.3 to -2.5 VDC
0 to 1.0 VDC