6: Verify Loop; 7: History; View Events - Fire-Lite MS-9200UDLS Manual

Programming
Pressing 2 while viewing the Node Mode Setup Screen will allow the programmer to enter the
address of the node on the Lite-Connect circuit..
A flashing cursor will appear in the lower left corner of the display. Enter the two-digit address
which can be a value between 02 and 17. (Address 01 is reserved for the hub.) After the second
digit is entered, the display will return to the Node Mode Setup screen.
3.6.6 Verify Loop
PROGRAMMING
Pressing 3 while viewing Programming Screen #2, will select the Verify Loop option. During loop
1=LOOP SETUP
2=SYSTEM SETUP verification, the FACP polls each device on the SLC to determine if the device is communicating
3=VERIFY LOOP
and whether or not it responds with the proper type identification. The following screen will be
Programming Screen #2
displayed while verification is in progress:
When Loop verification has been completed, the display will indicate that the system is OK or, if
problems have been detected, any device type programming errors. Use the up and down arrow
keys to view all detected errors.
3.6.7 History
PROGRAMMING
The History option allows an authorized user to view or erase events which have occurred in the
1=HISTORY
2=WALKTEST
control panel. Pressing 1 while viewing Programming Screen #3 will display the History options
3=OPTION MODULES
as shown in the following display:
Programming Screen #3

View Events

HISTORY
1=VIEW EVENTS
Pressing 1 while viewing the History Screen will allow the user to select the events to be viewed as
2=ERASE HISTORY
illustrated in the following:
History Screen
While displaying the View Events screen, press 1 to view all events, 2 to view only alarms or 3 to
view other events. Use the up and down arrow keys to scroll through all of the displayed events.
102
NODE ADDRESS
ENTER NODE ADDRESS
RANGE 02-17
Node Mode Setup Screen
VERIFYING LOOPS
PLEASE WAIT
Verification Progress Screen
HISTORY
1=VIEW EVENTS
2=ERASE HISTORY
History Screen
HISTORY
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
View Events Screen
MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Master Programming Level