Account Code; Hour Test Time; Phone Number; Communication Format - Fire-Lite MS-9200UDLS Manual

Master Programming Level
CENTRAL STATION
1=TEST TIME INT

2=ACCOUNT CODE

3=24HR TST TIME
Primary/Secondary Screen #1
CENTRAL STATION

1=PHONE NUMBER

Primary/Secondary Screen #2
CENTRAL STATION
1=COMM FORMAT
Primary/Secondary Screen #3
MS-9200UDLS Series Manual — P/N 52750:H 4/14/2014
Account Code
Pressing 2 while viewing Primary/Secondary Screen #1 will cause the following screen to be
displayed:
The Account Code, which is assigned by a Central Station, depends on the communication format
being used. The Account Code screen will have a flashing cursor in the lower left corner. Enter the
supplied account code using 0 - 9 and A- F keys.

24 Hour Test Time

Pressing 3 while viewing Primary/Secondary Screen #1 will cause the following screen to be
displayed:
Use the 24 Hour Test Time screen to program the time that the DACT will transmit the 24 Hour
Test to the Central Station. A flashing cursor will appear in the lower left corner of the screen.
Enter a four digit number representing the test time using military time (0000 = midnight and 2359
= 11:59PM).
Phone Number
Pressing 1 while viewing Primary/Secondary Screen #2 will cause the following screen to be
displayed:
The Phone Number screen is used to enter the Central Station phone number that the DACT will be
contacting. A maximum of 20 characters can be entered with valid entries being 0 - 9 and A - C
where A = *, B = # and C = 2 seconds pause.
A flashing cursor will appear in the lower left corner of the screen. Enter the first digit then press
the right arrow key to move the cursor to the right one position. Enter the second digit and repeat
the process until all digits are entered. Press the Enter key to store the phone number in memory.
Enter the digits as you would like the number to be dialed. For example, if it's necessary to dial 9
before dialing a number outside the building, you may wish to pause after dialing 9. Enter 9
followed by D for a three second pause or E for a five second pause then the phone number
followed by an F to indicate the end of the number.

Communication Format

Pressing 1 while viewing Primary/Secondary Screen #3 will cause the following screen to be
displayed:
ACCOUNT CODE
4 CHAR RANGE 0-F
Account Codes Screen
24 HOUR TEST TIME
RANGE 0000-2359
24 Hour Test Time Screen
PHONE NUMBER
20 NUMBERS MAXIMUM
Phone Number Screen
COMM FORMAT
1=ADEMCO CONTACT ID
2=SIA 8
3=SIA 20
Programming
121