Service Engr Id; Subscribe; Maintenance Start; Maintenance End - Konica Minolta bizhub C35 Service Manual

DRAFT
Field Service Ver. 1.0 Feb. 2010
10.13.3

Service Engr ID

A. Use
• To register the service engineer ID.
• Use when registering and changing service engineer ID.
B. Procedure
• Enter a 7-digit code with the up key /down key /right key /left key .
(0000001 to 9999999)
10.13.4

Subscribe

• Not displayed when the machine is registered in the CS Remote Care center.
A. Use
• Sent the information to the CS Remote Care center to register the machine.
B. Procedure
1. Select [Service Mode]→[CS Remote Care]→[Subscribe].
2. Press the Menu/Select key to start initial transmission.
10.13.5

Maintenance Start.

A. Use
• Starts the maintenance using the CS Remote Care.
• Not displayed in the following cases.
The machine is not registered in the center.
The Service Engineer ID is not registered.
The maintenance is already provided.
B. Procedure
1. Select [Service Mode]→[CS Remote Care]→[Maintenance Start.].
2. Select [Yes], and touch [OK] to start the maintenance.
10.13.6

Maintenance End.

A. Use
• Ends the maintenance provided by the CS Remote Care.
• Not displayed in the following cases.
The machine is not registered in the center.
The Service Engineer ID is not registered.
The maintenance is not provided.
B. Procedure
1. Select [Service Mode]→[CS Remote Care]→[Maintenance End.].
2. Select [Yes], and touch [OK] to finish the maintenance.
10. SERVICE MODE
163