DRAFT
10. SERVICE MODE
10.7.10
Retry Start Pg
A. Use
• Set whether, during redial, to start with the first page or the page in which an error occurs
during the transmission.
B. Procedure
• The default setting is Error Page.
1st Page
10.7.11
DT Detect
A. Use
• Set whether or not to detect the dial tone before dialing.
• No transmission is executed if the dial tone is not detected.
B. Procedure
• The default setting is ON.
"ON"
10.7.12
BT Detect
A. Use
• Set whether or not to detect the busy tone.
B. Procedure
• The default setting is ON.
"ON"
10.7.13
Cable Equalize
A. Use
• Set the cable equalizer setting value.
• Adjust this when communication fails.
B. Procedure
• The default setting is 0Km.
"0Km"
10.7.14
Echo Measure
A. Use
• Set whether or not to take the echo measure.
• Adjust this when communication fails.
B. Procedure
• The default setting is OFF.
ON
134
1.8Km
3.6Km
Field Service Ver. 1.0 Feb. 2010
"Error Page"
OFF
OFF
7.2Km
"OFF"