Thick Mode; Fine Line Adj; Main Scan Adjust; Main Scan Page - Konica Minolta bizhub C35 Service Manual

DRAFT
Field Service Ver. 1.0 Feb. 2010
10.5.12

Thick Mode

A. Use
• In order to prevent toner from clogging within the developer unit as a result of it being
driven at half-speed, select the timing for driving the developer unit at full speed for a
fixed length of time when thick paper is being fed.
Quality Mode: While printing on thick paper, printing is periodically paused, and the
developer unit is driven at full speed for a fixed length of time. Since
printing is paused, the quality is not affected; however, a standby time of
approximately 70 seconds occurs every 400 seconds or so of half-speed
operation.
Speed Mode: While printing on thick paper, only the drive of the developer unit periodi-
cally switches to full speed for a fixed length of time.
Since printing continues during full-speed drive, the print quality is
slightly affected, however the standby time is short.
B. Procedure
• The default setting is Quality Mode.
10.5.13

Fine Line ADJ

A. Use
• Adjust how fine lines are reproduced by changing the applied voltage (VC) to the electro-
static roller.
B. Procedure
• The default setting is 0.
NOTE
• The administrator can also make this setting by selecting [Admin Set-
→
tings] [Maintenance Menu]
However, the adjustable range of the parameter is narrowed to -3 to 2.

10.6 Main Scan Adjust

10.6.1

Main Scan Page

A. Use
• Prints the test pattern used for the main scan adjustment.
B. Procedure
1. Call the Service Mode to the display.
2. Touch [Main Scan Adjust]
3. Select [Print], and touch [OK].
4. The test pattern is output.
"Quality Mode"
-4 to 3
→
[Printer Adjustment]
→
[Main Scan Page].
10. SERVICE MODE
Speed Mode
→
[Fine Line ADJ].
129