Element Page - Konica Minolta bizhub C35 Service Manual

DRAFT
10. SERVICE MODE
10.9.4

Element Page

A. Use
• To print the engine element data information.
• To check the element data.
• See the attached chart listed below for details.
B. Procedure
1. Call the Service Mode to the display.
2. Touch [Print Menu]
3. Select [Print], and touch [OK].
C. Engine element data information
Element data name
Inside Humidity
INSIDE TEMPERATURE
PH TEMPRATURE
Sensor Information 1
Sensor Information 2
Sensor Information 3
Sensor Information 4
Sensor Information 5
Fuser Heater 1 Temperature
Fuser Heater 2 Temperature
IDC Sensor 1 PS
IDC Sensor 1 P
TONER LEVEL SENSOR C
TONER LEVEL SENSOR M
TONER LEVEL SENSOR Y
TONER LEVEL SENSOR K
VDC Volt C
VDC Volt M
VDC Volt Y
VDC Volt K
VPP Volt C
VPP Volt M
VPP Volt Y
VPP Volt K
VPP Volt Limit C
VPP Volt Limit M
VPP Volt Limit Y
VPP Volt Limit K
156
→
[Element Page].
• Displays the inside humidity (in 1% increments).
• Displays the inside temperature (in 1 ºC increments).
• Displays the PH temperature (in 1 ºC increments).
• Displays the input port status of the sensors and switches in
hexadecimal numbers.
• Displays the latest temperature on the middle of the heating roller
(in 1 ºC increments).
• Displays the latest temperature at the edges of the heating roller
(in 1 ºC increments).
• Shows the latest IDC data.
• Range of output: 0V to 9.99V (in 0.01V increments)
• Displays the number of times the toner level sensor has detected
an empty condition during one cycle of developer agitation.
• Range of output: 0 to 200 (in increments of one time)
• Displays the Vdc voltage of each color of toner.
• Range of output: -1000V to 255V (in 1V increments)
• Displays the Vpp voltage of each color of toner.
• Range of output: 700V to 2000V (in 1V increments)
• Displays the limit value of Vpp voltage of each color of toner.
• Range of output: 700V to 2000V (in 1V increments)
Field Service Ver. 1.0 Feb. 2010
Description