Figure 31-27 Frame-Type Command Example; Figure 31-28 Vlan-Trunking Command Example; Figure 31-29 Weight Command Example - ZyXEL Communications GS-3012 User Manual

GS-3012/GS-3012F User's Guide
Enable tagged frame-types on the interface.
ras(config)# interface port-channel 1,3-5
ras(config-interface)# ingress-check
ras(config-interface)# frame-type tagged
31.8.9 vlan-trunking
Syntax:
vlan-trunking
Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly connected to end
users) to allow frames belonging to unknown VLAN groups to pass through the switch.
An example is shown next.
Enable ports one, three, four and five for configuration.
Enable VLAN Trunking on the interface.
ras(config)# interface port-channel 1,3-5
ras(config-interface)# vlan-trunking
31.8.10 weight
Syntax:
weight <wt1> <wt2> ... <wt8>
where
<wt1> <wt2>
... <wt8>
An example is shown next.
Enable port two and ports six to twelve for configuration.
Set the queue weights from Q0 to Q7.
ras# configure
ras(config)# interface port-channel 2,6-12
ras(config-interface)# weight 8 7 6 5 4 3 2 1
31.8.11 egress set
31-14

Figure 31-27 frame-type Command Example

Figure 31-28 vlan-trunking Command Example

Sets the interface WFQ weighting. A weight value of one to eight is given to
each variable from wt1 to wt8.

Figure 31-29 weight Command Example

Command Examples