Configuring Snmp - ZyXEL Communications GS2210 Series User Manual

Figure 211 Management > Access Control

37.3 Configuring SNMP

Use this screen to configure your SNMP settings.
Click Management > Access Control > SNMP to view the screen as shown.
Figure 212 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 141 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
GS2210 Series User's Guide
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
SNMP version 2c is backwards compatible with SNMP version 1.
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Chapter 37 Access Control
297