ZyXEL Communications GS2210 Series User Manual page 175

Figure 123 Advanced Application > Multicast > Multicast Setup > MVR > Group Configuration
The following table describes the labels in this screen.
Table 72 Advanced Application > Multicast > Multicast Setting > MVR > Group Configuration
LABEL
Multicast VLAN ID
Group Name
Start Address
End Address
Add
Cancel
MVLAN
Group Name
Start Address
End Address
Delete
Cancel
GS2210 Series User's Guide
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down
list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to Section on page 164
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to Section on page 164
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select the entry(ies) that you want to remove in the Delete column, then click the
Delete button to remove the selected entry(ies) from the table.
If you delete a multicast VLAN, all multicast groups in this VLAN will also be removed.
Select Cancel to clear the checkbox(es) in the table.
for more information on IP multicast addresses.
for more information on IP multicast addresses.
Chapter 23 Multicast
175