ZyXEL Communications GS2210 Series User Manual page 130

Chapter 14 Bandwidth Control
Figure 94 Advanced Application > Bandwidth Control
The following table describes the related labels in this screen.
Table 48 Advanced Application > Bandwidth Control
LABEL
Active
Port
*
Active
Ingress Rate
Active
Egress Rate
Apply
Cancel
130
DESCRIPTION
Select this check box to enable bandwidth control on the Switch.
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to activate ingress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming traffic
flow on a port.
Note: Ingress rate bandwidth control applies to layer 2 traffic only.
Select this check box to activate egress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going traffic
flow on a port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields.
GS2210 Series User's Guide