ZyXEL Communications GS2210 Series User Manual page 140

Chapter 17 Link Aggregation
Figure 99 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 55 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
Link
Aggregation
Control
Protocol
Active
System
Priority
Group ID
140
DESCRIPTION
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP "server".
The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of
an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the
higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
GS2210 Series User's Guide