ZyXEL Communications GS2210 Series User Manual page 71

To view the current amount of power that PDs are receiving from the Switch, click Basic Setting >
PoE Setup.
Figure 48 Basic Setting > PoE Status
The following table describes the labels in this screen.
Table 14 Basic Setting > PoE Status
LABEL
PoE Status
PoE Mode
Total Power
Consuming
Power (W)
Allocated Power
(W)
Remaining
Power (W)
Port
State
GS2210 Series User's Guide
DESCRIPTION
This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
This field displays the amount of power the Switch is currently supplying to the connected
PoE-enabled devices.
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s).
Consuming Power (W) can be less than or equal but not more than the Allocated Power
(W).
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to supply power to a
PoE device, even if the PoE device needs less than 16W.
This is the port index number.
This field shows which ports can receive power from the Switch. You can set this in
8.8.1 on page 72.
• Disable - The PD connected to this port cannot get power supply.
• Enable - The PD connected to this port can receive power.
Chapter 8 Basic Setting
Section
71