ZyXEL Communications GS2210 Series User Manual page 125

Figure 89 Advanced Application > Spanning Tree Protocol > Status: MSTP
The following table describes the labels in this screen.
Table 47 Advanced Application > Spanning Tree Protocol > Status: MSTP
LABEL
Configuration
CST
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
Forwarding Delay
(second)
Cost to Bridge
Port ID
GS2210 Series User's Guide
DESCRIPTION
Click Configuration to specify which STP mode you want to activate. Click MSTP to edit
MSTP settings on the Switch.
This section describes the Common Spanning Tree settings.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this switch.
This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC address.
This ID is the same for Root and Our Bridge if the Switch is the root switch.
This is the time interval (in seconds) at which the root switch transmits a configuration
message.
This is the maximum time (in seconds) the Switch can wait without receiving a
configuration message before attempting to reconfigure.
This is the time (in seconds) the root switch will wait before changing states (that is,
listening to learning to forwarding).
This is the path cost from the root port on this Switch to the root switch.
This is the priority and number of the port on the Switch through which this Switch must
communicate with the root of the Spanning Tree.
Chapter 13 Spanning Tree Protocol
125