ZyXEL Communications GS2210 Series User Manual page 172

Chapter 23 Multicast
Figure 121 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
The following table describes the labels in this screen.
Table 70 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Start Address
End Address
Delete
Cancel
172
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Type the starting multicast IP address for a range of multicast IP addresses that you want
to belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong
to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to reset the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Click Cancel to clear the Delete Profile/Delete Rule check boxes.
GS2210 Series User's Guide