Service Port Access Control - ZyXEL Communications GS2210 Series User Manual

Table 145 Management > Access Control > Logins (continued)
LABEL
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give users
higher privileges via the CLI. For more information on assigning privileges see the Ethernet Switch CLI
Reference Guide.
User Name
Password
Retype to
confirm
Apply
Cancel

37.5 Service Port Access Control

Service Access Control allows you to decide what services you may use to access the Switch. You
may also change the default service port and configure "trusted computer(s)" for each service in
the Remote Management screen (discussed later). Click Access Control to go back to the main
Access Control screen.
Figure 217 Management > Access Control > Service Access Control
The following table describes the fields in this screen.
Table 146 Management > Access Control > Service Access Control
LABEL
Services
Active
Service Port
GS2210 Series User's Guide
DESCRIPTION
Set a user name (up to 32 ASCII characters long).
Enter your new system password.
Retype your new system password for confirmation
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to access the
Switch.
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by
typing the new port number in the Service Port field. If you change the default port
number then you will have to let people (who wish to use the service) know the new port
number for that service.
Chapter 37 Access Control
303