ZyXEL Communications GS2210 Series User Manual page 215

The following table describes the labels in this screen.
Table 92 Advanced Application > Loop Guard
LABEL
Active
Port
*
Active
Apply
Cancel
GS2210 Series User's Guide
DESCRIPTION
Select this option to enable loop guard on the Switch.
The Switch generates syslog, internal log messages as well as SNMP traps when it shuts
down a port via the loop guard feature.
This field displays the port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the loop guard feature on this port. The Switch sends probe
packets from this port to check if the switch it is connected to is in loop state. If the switch
that this port is connected is in loop state the Switch will shut down this port.
Clear this check box to disable the loop guard feature.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 26 Loop Guard
215