ZyXEL Communications GS2210 Series User Manual page 264

Chapter 32 Static Route
Table 120 IP Application > Static Routing > IPv4 Static Route (continued)
LABEL
Gateway IP
Address
Metric
Add
Cancel
Clear
Index
Active
Name
Destination
Address
Subnet Mask
Gateway
Address
Metric
Delete
Cancel
264
DESCRIPTION
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch
that will forward the packet to the destination. The gateway must be a router on the same
segment as your Switch.
The metric represents the "cost" of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good number.
Click Add to insert a new static route to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the above fields to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
This field displays the index number of the route. Click a number to edit the static route
entry.
This field displays Yes when the static route is activated and NO when it is deactivated.
This field displays the descriptive name for this route. This is for identification purposes only.
This field displays the IP network address of the final destination.
This field displays the subnet mask for this destination.
This field displays the IP address of the gateway. The gateway is an immediate neighbor of
your Switch that will forward the packet to the destination.
This field displays the cost of transmission for routing purposes.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
GS2210 Series User's Guide