General Mvr Configuration - ZyXEL Communications GS2210 Series User Manual

23.5 General MVR Configuration

Use the MVR screen to create multicast VLANs and select the receiver port(s) and a source port for
each multicast VLAN. Click Advanced Application > Multicast > Multicast Setup > MVR to
display the screen as shown next.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the
Switch.
Note: Your Switch automatically creates a static VLAN (with the same VID) when you
create a multicast VLAN in this screen.
Figure 122 Advanced Application > Multicast > Multicast Setup > MVR
The following table describes the related labels in this screen.
Table 71 Advanced Application > Multicast > Multicast Setting > MVR
LABEL
Active
Group Name
Multicast VLAN ID
802.1p Priority
GS2210 Series User's Guide
DESCRIPTION
Select this check box to enable MVR to allow one single multicast VLAN to be shared
among different subscriber VLANs on the network.
Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
Enter the VLAN ID (1 to 4094) of the multicast VLAN.
Select a priority level (0-7) with which the Switch replaces the priority in outgoing IGMP
or MLD control packets (belonging to this multicast VLAN).
Chapter 23 Multicast
173