ZyXEL Communications GS2210 Series User Manual page 253

Figure 177 Advanced Application > LLDP > LLDP Configuration
The following table describes the labels in this screen.
Table 114 Advanced Application > LLDP > LLDP Configuration
LABEL
Active
Transmit Interval
Transmit Hold
Transmit Delay
Reinitialize Delay
Apply
Cancel
Port
Admin Status
Notification
GS2210 Series User's Guide
DESCRIPTION
Select to enable LLDP on the Switch. It is disabled by default.
Enter how many seconds the Switch waits before sending LLDP packets.
Enter the the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The
TTL value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Enter the delay (in seconds) between successive LLDP PDU transmissions initiated by
value or status changes in the Switch MIB.
Enter the number of seconds for LLDP to wait before initializing on a port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
This displays the port number with this LLDP configuration. * means all ports.
Select whether LLDP transmission and/or reception is allowed on this port.
• Disable - not allowed
• Tx-Only - transmit only
• Rx-Only - receive only
• Tx-Rx - transmit and receive
Select whether LLDP notification is enabled on this port.
Chapter 31 Link Layer Discovery Protocol (LLDP)
253