Inverter Upper Roller Motor - Xerox Paser 7400 Service Manual

Inverter Upper Roller Motor

1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Remove the Inverter Rear Covers (page 5-19).
3. Disconnect the 4-wire cable from the Inverter Controller Board connector labeled
Motor_B. Be sure to lift the cable harness out of the cable guides.
4.
Remove one screw (metal flange, 6 mm) from the upper right (and its
anti-vibration spring) and one screw from the lower left of the motor.
5.
Pull the motor and its associated gear free from the gear assembly.
Service Parts Disassembly
Upper Roller
Motor
s7400-492
5-67