4.
After adjusting the folding position, set all bits of SW1 on the Finisher Controller
Board to OFF (this action will ensure that the switch will no longer affect the
settings).
5.
Enter the booklet mode of the printer and check whether the folding position is
adjusted properly. If necessary, repeat the procedure.
Adjusting the Phase of the Saddle Unit Gear
If you replace or remove the gears at the front of the saddle unit or the paper fold
rollers in the saddle unit, adjust the gear phase using the following procedure:
1.
Position the paper fold rollers and saddle cam as shown below.
4-18
Phaser 7400 Color Printer Options Service Manual
Saddle Cam
Paper Fold Rollers
s7400-213