Alignment (Front And Rear) Motors - Xerox Paser 7400 Service Manual

Alignment (Front and Rear) Motors

1.
Remove the Paper Exit Tray (page 5-7).
2.
Remove the Front Door (page 5-8).
3. Remove the Rear Cover (page 5-11).
4. Remove the Upper Cover (page 5-13).
5. Remove the Side Guide (page 5-107).
6.
Refer to the illustration below to locate both Alignment Motors.
Rear Alignment Motor
7. To remove either motor, first remove the 5-wire connector (CN63 Front, and
CN65 Rear) from the motor, and then remove two screws (metal, 6 mm) and a
washer holding the motor to the paper guide.
Service Parts Disassembly
Front Alignment Motor
CN65
CN63
s7400-702
5-65