Finisher Jog Motor Failure - Xerox Paser 7400 Service Manual

Finisher Jog Motor Failure

An error was detected in either the Front or Rear Alignment Motor.
Applicable Status Code:
Code F93:
Jog Motor Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paddle Assembly
Alignment Motors
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Paddle Assembly
Alignment Motors
Is there any damage?
2 Test the Alignment Plate Sensors.
Run the Service Diagnostics Front and
Rear Alignment Plate Sensor tests.
Do the sensors function correctly?
General Troubleshooting
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Finisher Controller to Motors
Yes
Replace any
damaged parts.
Replace the Paddle
Assembly
(page 5-43),
No
Go to Step 2.
Replace the
sensor.
3-57