Inverter Lower Roller Solenoid - Xerox Paser 7400 Service Manual

Inverter Lower Roller Solenoid

1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Remove the Inverter Rear Covers (page 5-19).
3. Remove the Top Cover (page 5-23).
4. Disconnect the cable from the Inverter Controller Board. Be sure you free the
cable harness from the cable guide.
5.
Remove the Inverter Controller Board (page 5-55).
6. Remove the Power Supply Board (page 5-56).
7. Remove the tension spring from the solenoid and swing plate.
8. From the chassis side, carefully free the paper guide from the swing plate.
9.
Remove two screws (metal flange, 6 mm) from the solenoid casing.
10.
To remove the solenoid unit, remove two small brass screws (metal, 4 mm) from
the solenoid casing and lift the relay from the casing.
Service Parts Disassembly
Lower Roller
Solenoid Casing
s7400-493
5-71