Inverter Paper-In Sensor - Xerox Paser 7400 Service Manual

Inverter Paper-in Sensor

The Inverter Paper-in Sensor detects the presence of media in the Inverter. To remove
the sensor:
1. Remove the Inverter and base unit from the Finisher (page 5-5).
2. Remove the Inverter Front Covers (page 5-17).
3.
Remove the Inverter Rear Covers (page 5-19).
4. Remove the Top Cover (page 5-23).
5. Remove six screws (metal flange, 6 mm) from the actuator cover metal plate.
6.
Disconnect the 3-wire connector at the actuator location.
Note
The other end of this cable connects to connector (SNSCN0) on the Inverter
Controller Board.
7. Pinch the plastic hooks together to free the actuator from the metal support case,
then pinch the plastic tab to pull the actuator free from the chassis.
5-106
Connector
Hooks
Paper In Sensor
Phaser 7400 Color Printer Options Service Manual
s7400-497