Swing Guide Home Position Sensor - Xerox Paser 7400 Service Manual

Swing Guide Home Position Sensor

The Swing Guide Home Position Sensor detects the home position for the Swing
Guide. To remove the sensor.
1. Remove the Paper Exit Tray (page 5-7).
2. Remove the Rear Cover (page 5-11).
3.
Remove the Upper Cover (page 5-13).
4.
Remove two screws (metal, 6 mm) and remove the swing guide cover.
5.
Locate the sensor (see illustration) and disconnect connector CN41.
Folding Position Sensor
6.
To remove the sensor, pinch the plastic tabs with needle nose pliers, and then pull
the sensor free.
Service Parts Disassembly
Swing Guide Home Position Sensor
Stack Feed Roller
Home Position Sensor
Folding Home
Position Sensor
s7400-659
5-89