Table of Contents
Advertisement
Interconnect Connector
The Duplex Unit Connector transfers signals between the printer and the Duplex
Controller Board. To remove the connector.
1.
Remove the Front Door and Front Cover Assembly (page 5-122).
2.
Disconnect the Duplex Connector plug from the controller (MAIN1).
3.
Free the cable harness from the chassis.
4.
Remove two screws (metal, 4 mm) from the connector and lift the connector and
cable from the chassis.
5-132
Phaser 7400 Color Printer Options Service Manual
Duplexer Connector
s7400-508
Advertisement
Table of Contents
Troubleshooting
