Tray Covers And Tray Door (Door C) - Xerox Paser 7400 Service Manual

Tray Covers and Tray Door (Door C)

Note
If optional trays are installed, either remove the printer from the optional tray(s),
or lift the right hand side of the printer to provide sufficient clearance to remove
4 screws and pull the Tray Feeder from the frame.
To remove or replace any of the clutches, motors, or sensors, you must first remove
either or both the Rear Cover and the Right Side Cover (and in some cases, you will
need to remove the tray itself on the front of the unit or open the Tray door, Door C).
To replace the Rear Cover or the Right Side Cover:
1.
Remove five screws (metal flange, 6 mm) fastening each plastic cover to the
chassis frame.
2.
With a screwdriver, press down inside of the tab slots to pop the plastic cover
away from the frame.
Lower Rear Cover
3.
On some disassembly of sensors or diagnostic testing, you may need to open the
Tray Door (Door C).
5-134
Tab Slot
Phaser 7400 Color Printer Options Service Manual
Tab Slot
s7400-525