Finisher Stapler Swing Motor Failure
The Stapler Swing Home Position Sensor detected a Stapler Swing Motor error.
Applicable Status Code:
Code F106:
Swing Motor Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Stapler Swing Motor
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1
Test the Stapler Swing Home Position
Sensor
Run the Service Diagnostics Stapler Slide
Home Position Sensor test.
Do the sensors operate?
2
Test the Swing Motor.
1. Close the Interlock Switches for test.
2. Run the Service Diagnostics Sliding
Motor test.
Does the motor operate?
3
Check for +24 V to the Swing Motor.
Disconnect CN72.
Is there +24 V across CN72-8 and -9 <=>
ground?
4
Check all pins of the Inverter Interface
Cable for continuity.
Disconnect CN1 and CN2 from the Finisher
Control Board and the opposite end from
the Inverter.
Is the cable conductive?
3-54
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Finisher Controller to Switches
Phaser 7400 Color Printer Options Service Manual
Yes
Go to Step 2.
Replace the
Finisher Control
Board (page 5-46).
If the error persists,
go to Step 4.
Replace the Slide
Motor (page 5-61).
Replace the Inverter
Power Supply
(page 5-56).
No
Replace the
sensor. If the error
persists, go to
Step 2.
Go to Step 4.
Replace the
harness. If the
error persists, go
to Step 5.
Replace the cable.