Xerox Paser 7400 Service Manual page 383

Finisher/Plug/Jack Designators (Continued)
P/J Map Coord
CN17 1 A-841
CN18 1 E-834
CN19 1 I-839
SW1 1 C-841
PSW3 1 B-840
PSW2 1 C-840
PSW1 1 D-840
LED3 1 B-839
LED2 1 C-839
LED1 1 D-839
CB1 1 B-835
Punch Controller Board Plug/Jack Designator
P/J Map Coord
J1001 2 H-838
J1002 2 H-840
J1003 2 D-842
J1004 2 G-842
J1005 2 H-835
J1006 2 H-836
J1007 2 D-834
SW1001 2 E-837
SW1002 2 E-838
SW1003 2 E-839
LED100 2 E-839
1
LED100 2 E-840
2
LED100 2 E840
3
Wiring Diagrams
Remarks
Connects to signal ground, transmit and receive data, DSR and
DTR signals, and reset.
Supplies 24 volts to the Slide motor.
Connects to the full stack sensor.
Folding position adjustment, middle 2-point stapling.
Factory mode
Folding position adjustment, middle 2-point stapling.
Folding position adjustment, middle 2-point stapling.
LED for PSW1.
LED for PSW2.
LED for PSW3.
Circuit breaker between Joint Switch and 24 volts from the printer.
Remarks
Connects to Finisher Punch Transfer Motor.
Connects to Punch Motor.
Connects to CN12 of Finisher Unit.
Connects to CN14 of Finisher Unit.
Connects to waste-full photosensor board and the Waste-full LED
board.
Connects to punch motor clock, punch home, and punch home
position sensors.
Connects to the photosensor and LED boards.
Punch hole count registration/sensor output adjustment, etc.
Punch hole count registration/sensor output adjustment, etc.
Punch hole count registration/sensor output adjustment, etc.
Determines number of punch holes (see page 4-2).
Determines number of punch holes (see page 4-2).
Determines number of punch holes (see page 4-2).
7-3