Inverter Feeder Clutch - Xerox Paser 7400 Service Manual

Inverter Feeder Clutch

1.
Remove the Inverter and base unit from the Finisher (page 5-5).
2.
Remove the Inverter Rear Covers (page 5-19).
3. Remove the Inverter Top Cover (page 5-23).
4. Disconnect the two-wire connector from connector plug (FAN) on the Inverter
Controller Board. Make sure you also pull the wires free from the cable guides.
5.
Remove the screw (metal flange, 6 mm) and anti-vibration spring from the lower
left side of the clutch.
6. Remove the e-clip from the end of the clutch.
7.
With the anti-vibration spring and e-clip removed, you can pull the clutch and its
gear free from the roller gear assembly.
Service Parts Disassembly
Anti-Vibration Spring
Feeder Clutch
s7400-495
5-69