Upper Feed Roller Assembly; Remove The Upper Feed Roller Assembly (Left Side) - Xerox Phaser 840 Service Manual

Upper feed roller assembly

Remove the right cover.
1.
Remove the left cover.
2.
Disconnect the head tilt spring.
3.
Left side: Remove the upper feed roller electric clutch from the end of the upper feed
4.
roller shaft.
Remove the feed-roller drive belt and compound gear from the left end of the upper
5.
feed roller. Note the small slot in the compound gear to ease removal.
Upper feed roller electric clutch
Fig 7-6 Remove the upper feed roller assembly (left side)
Open the front door and remove the drum maintenance drawer. Also, remove
6. Front:
the bright, metal duplex paper guide from the front of the printer. It is held in place
with two screws.
Remove the left and right maintenance drawer guides. Each is held in place by a single
7.
screw at the front and two frame latches at the rear.
Slot
Compound gear
Removal and Replacement Procedures
Disconnect
head tilt
spring
Upper feed
roller shaft
Feed drive
belt
840-4-13
7 - 185