Custom Menu Display - Sanwa M11X Operating Manual

custom menu display

The Custom Menu function allows you to create up to three Custom Function Pages (C1, C2, and C3) that replace the Default
Function Pages (F1, F2, and F3). This makes programming the transmitter more user-friendly, since you can place your most
accessed menus onto one or more Custom Function Pages.
1) Press the Function key to highlight the C-MENU menu.
The cursor will default to the upper left box in the C1
Custom Function Page in the Programming Window.
2) Press the INC/+ or DEC/- keys to scroll through the
different Menu selections along the right side of the
Programming Window. The selected Menu will display
in the upper left box in the C1 Custom Function Page.
3) Press the ENTER key to move the cursor to the next
box in the C1 Custom Function Page, then press the
INC/+ or DEC/- keys to scroll through the different
Menu selections to display the selected Menu.
4) Repeat step 3 to add your most accessed menus into
the remaining boxes in the C1 Custom Function Page.
Press the ENTER key after filling in the lower right box in the C1 Custom Function Page to cycle to the C2 Custom Function
Page. If desired, continue adding your most accessed menus into the C2 and C3 Custom Function Pages.
5) After setting your Custom Function Pages, press and
hold both Function keys down at the same time for ~ 2
seconds to swap between the default Function Pages
and your Custom Function Pages.
Function Page 3 (C-MENU)
Page 59