Sanwa M11X Operating Manual page 52

key assignments
Function Selection Setting
1) Press the Function key to move the cursor to [TRIM] in the Programming
Window. The cursor will default to TRM1.
2) Press the INC/+ or DEC/- keys to set the desired Function to be
controlled by Trm 1.
Trim Step Setting
1) Press the ENTER key to move the cursor to STEP, then press the
INC/+ or DEC/- keys to adjust the desired STEP value for Trm 1.
Increasing the STEP value causes the servo to move less with each
press of the Trim Switch (higher trim resolution). Decreasing the
STEP value causes the servo to move more with each press of the Trim
Switch (lower trim resolution).
There are two different STEP values for the TRM-S function, 'C' (Center) and 'P' (Parallel). When 'P' is selected, End Point
parameters will be adjusted so that servo travel will be equal both left and right regardless of the trim setting. When 'C' is
selected, End Point parameters are not adjusted, therefore, servo travel will not be equal both right and left. This setting can be
changed only for the Steering Trim. All other trims utilize Center trim.
Trim Direction Setting
1) Press the ENTER key to move the cursor to REV, then press the INC/+
or DEC/- keys to set the desired trim direction value.
-ASGN TRIM REV setting range is NOR and REV. The default setting
is NOR. When set to NOR, the trim switch will move the servo the same
direction as the steering wheel. When set to REV, the trim switch will
move the servo the opposite direction as the steering wheel.
2) Follow the same procedures to assign and/or change functions for Trm 2, Trm 3, Trm 4, Trm 5, and DIAL.
Use the table below to help you assign the different Functions to the Trim Switches and the Dial Knob.
FuNCTION
Dual Rate
End Point Adjustment - Steering
End Point Adjustment - Brake
Exponential - Steering
Exponential - Throttle High
Exponential - Brake
Adjustable Rate Control - Steering Rate
Adjustable Rate Control - Steering Point
Adjustable Rate Control - Throttle High Rate
Adjustable Rate Control - Brake Rate
Adjustable Rate Control - Throttle High Point
Adjustable Rate Control - Brake Point
MENu DEFAuLT STEP SETTING
D/R 1 (1-10)
EPA-S 1 (1-10)
EPA-B 1 (1-10)
EX-S 1 (1-10)
EX-H 1 (1-10)
EX-B 1 (1-10)
AR-S-R 1 (1-10)
AR-S-P 1 (1-10)
AR-H-R 1 (1-10)
AR-B-R 1 (1-10)
AR-H-P 1 (1-10)
AR-B-P 1 (1-10)
Page 52
DEFAuLT SWITCH
Trm 4
Trm 5