Sanwa M11X Operating Manual page 41

brake mixing
3CH-Brake Setting
1) Press the ENTER key to move the cursor to 3CH-BRAKE in the
Programming Window, then press INC/+ or DEC/- keys to either Activate
or Inhibit the 3rd Channel Brake.
When you set 3CH-BRAKE to ACT, the 3CH DELAY option becomes
available.
BR-MIX 3CH-BRAKE setting range is INH to ACT. The default setting is INH. When set to ACT, the 3rd channel brake servo is
Activated and the 3CH DELAY value can be set. When set to INH, the 3rd channel brake servo will not function.
3CH Delay Setting
1) Press the ENTER key to move the cursor to 3CH in the Programming
Window, then press INC/+ or DEC/- keys to adjust the desired 3CH
DELAY value.
BR-MIX 3CH DELAY setting range is 0% to 100%. The default setting is
0%. The 3CH DELAY setting controls the speed of the 3rd channel brake
servo. When the value is increased the speed of the 3rd channel brake
servo is slowed.
TH-Brake Cut Setting
1) Press the ENTER key to move the cursor to TH-BRAKE CUT in
the Programming Window, then press INC/+ or DEC/- keys to either
Activate or Inhibit the Throttle Brake Cut.
BR-MIX TH-BRAKE CUT should ONLY be set to ACT if you are using
one or two separate brake servos. If you set TH-BRAKE CUT to ACT
while only using the 2nd channel brake (throttle/brake on the same servo),
you will not have any brake function!
BR-MIX TH-BRAKE CUT setting range is INH to ACT. The default setting is INH. When set to ACT, the Brake Side of the
throttle servo will not function, but the 4th channel brake servo (and the 3rd channel brake servo if set to ACT) will continue
to function. When set to INH, both the Brake Side of the throttle servo and any separate Brake servos will function normally.
With Transmitter Set to 2CH Mode
The Brake Mixing function can also be used when the transmitter is set to 2CH Mode, although Brake Mixing functionality is
highly reduced. The following Brake Mixing settings are available in 2CH Mode:
2CH Delay Setting
1) Press the Function key to highlight the BR-MIX menu. The cursor will default to DELAY-2CH in the Programming Window.
2) Press INC/+ or DEC/- keys to adjust the desired 2CH DELAY value. This setting operates the same as the 2CH DELAY
setting described on the previous page.
TH-Brake Cut Setting
1) Press the ENTER key to move the cursor to TH-BRAKE CUT in the Programming Window, then press INC/+ or DEC/- keys to
either Activate or Inhibit the Throttle Brake Cut. This setting operates the same as the TH-BRAKE CUT setting described above.
Even when the transmitter is set to 2CH Mode, the 4th Channel Brake will function if you're using a 4 channel receiver.
Page 41