Model Naming - Sanwa M11X Operating Manual

model naming

The Model function allows you to make settings related to Model Select (SELECT), Model Name (NAME), and Model Copy/Model
Clear (COPY/CLEAR) functions. Data for up to 30 different models can be stored in the transmitter's built-in EEPROM memory.
This allows you to use the transmitter with different models and quickly and easily select the programming for each of them.
[ SELECT ] MOdEL SELECT
Data can be stored for any model M01 to M30. Since previous model memories are stored automatically, there is no risk for
accidental erasing.
1) Press the Function key to highlight the MODEL menu.
[SELECT] will be active in the Programming Window
and the cursor will default to the currently active model.
2) Press the INC/+ or DEC/- keys to scroll the cursor to
the model you would like to select. There are five
separate model pages. The current page you are on is
displayed in the lower right corner of the screen.
WARNING
Do not attempt to change the model when your model's receiver is turned on under actual operational conditions. Your model
may run away or the servos may be damaged.
The model changes immediately upon selection.
Pages can be flipped through in sequence by pressing the INC/+ or DEC/- keys at the same time.
[ NAME ] MOdEL NAME
Model names can consist of up to 12 letters, numerals, or symbols. Naming your different models makes it much easier to find
and activate a particular model within the MODEL SELECT screen.
1) Press the Function key to move the cursor to [NAME]
in the MODEL Programming Window. The cursor will
blink next to the M01 selection.
2) The cursor will blink next to the M01: selection. Press
the ENTER key to move the cursor to the right and
press the key to move the cursor to the left.
3) Press the INC/+ or DEC/- keys to select a character,
then press the ENTER key to advance the cursor to the
next space. Repeat to enter the rest of the characters.
To erase a character, move the cursor under the
character you want to erase, then press the INC/+
and DEC/- keys at the same time until the single dark block
(Erase Block) is selected. The underlined character will
be erased.
A group of character styles can be selected by pressing the INC/+ and DEC/- keys at the same time. Choose from capital
letters, lower case letters, symbols, higher case numerals, and lower case numerals.
When entering a character in a position occupied by a space, a group can be selected from the preceding character by first
pressing the DEC/- key. This is useful when entering several characters from the same group.
Function Page 1 (MODEL)
Page 31