Key Assignments - Sanwa M11X Operating Manual

key assignments

The Key Assign function allows you to assign different functions to the Push-Button Switches (Sw 1, Sw2 , and Sw3) and the Trim
Switches (Trm 1, Trm 2, Trm 3, Trm4, and Trm 5). When the transmitter is set to 4CH Mode, Auxiliary Channel 3 can be assigned
to the Dial Knob or to any of the five Trim Switches. The Key Assign function also allows you to change the Trim Resolution of the
five Trim Switches. This allows you to fine-tune the movement of the servos when the Trim Switches are pressed.
Dial Knob
Push-Button
Switch (Sw 1)
Trim Control
Switch (Trm 2)
The following Switch and Trim Functions are the factory default settings:
Trm 1 - Steering Trim
Trm 2 - Throttle Trim
Trm 3 - 4th Channel Brake Trim
Trm 4 - Dual Rate
Trm 5 - Brake End Point Adjustment
[ SW ] SWITCH KEY ASSIGN
The Switch Key Assign function allows you to assign the ON/OFF control of various functions to Sw 1, Sw 2, and Sw 3. This allows
you to use the Push-Button switches to turn functions ON (Active) and OFF (Inhibit) during use. Up to three different functions
(FUNC1-FUNC3) can be assigned to a single Push-Button switch and turned ON and OFF simultaneously.
Highlighted functions in the
Switch Function Display
Screen in the Information Window
are Active. If a function is not
highlighted, i t i s n o t currently
Active.
Trim Control
Trim Control
Switch (Trm 1)
Switch (Trm 3)
Trim Control
Switch (Trm 4)
Trim Control
Switch (Trm 5)
Sw 1 - Starting Position ON/OFF
Sw 2 - Anti-Lock Brake ON/OFF
Sw 3 - Timer ON/OFF
Three different functions assigned to one switch.
Page 50
Function Page 3 ( -ASGN)
Push-Button
Switch (Sw 3)
Push-Button
Switch (Sw 2)
Dial Knob - Function Keys
Switch
Function
Display