Exponential - Sanwa M11X Operating Manual

EXPONENTIAL

The Exponential function varies the amount of servo action with respect to manipulation of the steering wheel or throttle trigger
near the neutral positions. Decreasing the Exponential value will 'soften' the control feel around neutral and increasing the
Exponential value will 'quicken' the control feel around neutral. Using a lower negative value allows for smoother control. Using
a higher positive value may result in more 'twitchy' control response.
Mild
(-1% to -100%)
Amount of steering wheel operation
on the 'L' side (amount of throttle
trigger operation on the 'H' side).
[ ST ] STEErING EXPONENTIAL
Steering Exponential can be variably adjusted from Mild through Linear to Quick to allow you to set the most effective steering
response for your model. Generally, if your model over-steers, reduce the Exponential value, and if your model under-steers,
increase the Exponential value.
1) Press the Function key to highlight the EXP menu. [ST] will be active in
the Programming Window and the cursor will default above TWEAK.
2) Press the INC/+ or DEC/- keys to set the desired Exponential value.
Changes to the steering Exponential affects both right and left
steering equally.
EXP-ST setting range is between -100% (Mild) to 100% (Quick). The default setting is 0% (Linear).
TWEAK Setting
Use the TWEAK setting when you want to fine-tune the left and right
steering balance. This allows you to move and pinpoint the neutral position
of the Exponential function independently anywhere between the Steering
End Points, not just the center. This ensures that Exponential is balanced
for both the right and left sides.
1) Press the ENTER key to move the cursor to the TWEAK setting.
2) To adjust left-hand steering, turn the steering wheel to the left. The cursor will point to the left. Press the INC/+ or DEC/- keys
to adjust the parameters. To adjust the right-side steering, turn the steering wheel to the right. The cursor will point to the right
and press the INC/+ or DEC/- keys to adjust the parameters.
EXP ST TWEAK setting range is between -20 to 20. The default setting is 0.
Quick
(1% to 100%)
Linear
(0%)
Neutral
Position
Page 21
Function Page 1 (EXP)
Quick
(1% to 100%)
Linear
(0%)
(-1% to -100%)
Amount of steering wheel operation
on the 'R' side (amount of throttle
trigger operation on the 'B' side).
Mild