Transmitter And Receiver Binding - Sanwa M11X Operating Manual

transmitter and receiver binding

When new, it is necessary to pair the transmitter and receiver to prevent interference from radio controllers operated by other
users. This operation is referred to as 'binding'. Once the binding process is complete, the setting is remembered even when the
transmitter and receiver are turned OFF, therefore, this procedure usually only needs to be done once. Under some circumstances,
the receiver may not operate after turning the transmitter and receiver ON. If this occurs, perform the binding process again.
Before beginning the binding process, plug your receiver battery into the switch, then plug the switch into the BATT/DSC
slot in the receiver, making sure that the polarity is correct. Make sure that both the transmitter and receiver are turned OFF.
1) Turn on the transmitter, then press the two Function keys at the same
time until Function Menu F3 is displayed. If the SET-UP menu is not
automatically highlighted, continue to press the Function key until the
SET-UP menu is highlighted.
2) With the SET-UP menu highlighted, press the Function key to select
[BIND] in the Programming Window. SET BIND BUTTON will be
displayed in the Programming Window.
3) Press the key. SEND BIND COMMAND will be displayed in the
Programming Window.
4) While holding down the Bind Button on the receiver, turn the
receiver ON. The Bind LED on the receiver will blink slowly.
Use the tip of a pencil or a 1.5mm hex wrench to reach the Bind
Button on the receiver.
5) After ~ 2 seconds release the Bind Button. The Bind LED on the
receiver will continue to blink slowly. Quickly press the ENTER key on the
transmitter. SENDING will be displayed in the Programming Window,
the Bind LED on the receiver will blink rapidly, then the Bind LED on the
receiver will turn solid indicating the binding process is complete.
After releasing the Bind Button, you must press the ENTER key quickly (within a couple of seconds). If you take too much
time, you will need to restart the binding process.
When the binding procedure is successful, the Bind LED on the receiver will stay solid blue when both the transmitter and
receiver are turned ON. If the Bind LED on the receiver is blinking rapidly, the transmitter and receiver are not paired. In
this case, turn both the transmitter and receiver OFF, then repeat the binding procedure.
The M11X FHSS-3 2.4GHz radio control system uses FHSS-3 technology. The transmitter is compatible with FHSS-3 and
F HSS-2 SANWA 2.4GHz receivers. To bind the transmitter to an FHSS-2 receiver (RX-442), the transmitter modulation must
first be changed to FH2. Formore information, please see page 47.
Page 13