Sanwa M11X Operating Manual page 47

Transmitter set-up
LCD Display Backlight Mode Setting
1) Press the ENTER key to move the cursor to LIGHT-MODE, then press
the INC/+ or DEC/- keys to select KEY-ON, OFF, or ALWAYS.
SET-UP SYSTEM LIGHT-MODE setting range is KEY-ON, OFF, and
ALWAYS. The default setting is KEY-ON. When set to KEY-ON, the
LCD Display backlight will turn ON when any key on the transmitter is
pressed. When set to OFF, the LCD Display backlight will be disabled.
When set to ALWAYS, the LCD Display backlighting will stay ON as long
as the transmitter is powered ON.
When set to OFF or ALWAYS the LIGHT-TIME setting described below is not available.
LCD Display Backlight Time Setting
1) Press the ENTER key to move the cursor to LIGHT-TIME, then press
the INC/+ or DEC/- keys to adjust the desired Time value.
SET-UP SYSTEM LIGHT-TIME setting range is 1 second to 30 seconds.
The default setting is 10 seconds. This setting adjusts the time in seconds
that the LCD Display backlight will stay ON after the last key-press.
The longer the LCD Display backlight is allowed to stay ON, the quicker the battery will be drained.
[ MOD ] MODULATION AND CHANNEL MODE SET-UP
The Modulation Set-up function allows you to choose the transmitter Modulation Type and Channel Mode (2CH or 4CH), and
Analog and/or Digital servo selection.
Modulation Type Setting
1) Press the Function key to move the cursor to [MOD] in the Programming
Window. The cursor will default to TYPE.
2) Press the INC/+ or DEC/- keys to set the desired Modulation Type.
SET-UP MOD TYPE setting range is FH2, FH3, and FH3F. The default
setting is FH3.
The following options are available:
FH2 - Select this Modulation Type when using legacy SANWA 2.4GHz FHSS-2 receivers. (RX-442FS)
FH3 - Select this Modulation Type when using SANWA 2.4GHz FHSS-3 receivers (stock).
FH3F - Select this Modulation Type when using SANWA 2.4GHz FHSS-3 receivers. Choose FH3F ONLY if using your
transmitter in France.
Channel Mode Setting
1) Press the ENTER key to move the cursor to CHANNEL, then press the
INC/+ or DEC/- keys to set the desired Channel Mode.
SET-UP MOD CHANNEL setting range is 2 and 4. The default setting
is 4 in FH3 and FH3F, and 2 in FH2. Selecting 2 will enable
2-channel operation (Steering and Throttle). Selecting 4 will enable
4-channel operation (Steering, Throttle, 3rd Channel Auxiliary, and 4th
Channel Brake.
Page 47