Starting Position - Sanwa M11X Operating Manual

starting position

The Starting Position function is used primarily with glow- or gas-powered models. It allows you to open the throttle a desired
amount and hold it there with only the press of a button. This makes it easier to start the engine. With the transmitter set to 4CH
Mode, a desired amount of braking can be applied independently making it possible to obtain safer engine starts by applying the
brakes while still keeping throttle open a desired amount.
The independent brake function is only available when the transmitter is set to 4CH Mode and you're using a separate
brake servo plugged into Channel 4.
S-POS Range
-100% - 100%
H
High Side
S-POS
Starting Position Setting
1) Press the Function key to highlight the S-POS menu. The cursor will
default to S-POS in the Programming Window.
2) Press INC/+ or DEC/- keys to adjust the desired S-POS value.
S-POS S-POS setting range is -100% to 100%. The default setting is 0%.
The S-POS setting controls how far the throttle servo will hold open the
carburetor when SPO is activated.
Alarm Setting
1) Press the ENTER key to move the cursor to ALARM in the Programming
Window, then press INC/+ or DEC/- keys to set the ALARM ON or OFF.
S-POS ALARM setting range is ON or OFF. The default setting is ON. The
ALARM will sound when S-POS is activated.
Offset Setting
1) Press the ENTER key to move the cursor to OFFSET in the Programming Window, then press INC/+ or DEC/- keys to set the
desired OFFSET value.
S-POS OFFSET setting range is INH, NEUT, and BR. The default setting is INH. When set to INH or NEUT, only the throttle
will open to the S-POS setting when S-POS is activated. When set to BR, the 4th-channel brake servo will travel to the BRAKE-
POINT setting, in addition to the throttle opening to the S-POS setting, when S-POS is activated.
Brake-Point Setting
1) Make sure that the OFFSET is set to BR, then press the ENTER key to
move the cursor to BRAKE-POINT in the Programming Window.
2) Press INC/+ or DEC/- keys to adjust the desired BRAKE-POINT value.
S-POS BRAKE-POINT setting range is 0% to 100%. The default setting is
0%. The BRAKE-POINT setting controls how far the 4th-channel Brake
servo will travel when SPO is activated.
BRAKE-POINT Range
0% - 100%
N
B
Brake Side
BRAKE-POINT
Page 38
Function Page 2 (S-POS)
By default the S-POS function is
assigned to Sw 1. S-POS can be
assigned to another Push-Button switch,
using the Key Assign function. See page
50 for more information. We suggest that
S-POS be assigned to it's own switch.