Track Timers - Sanwa M11X Operating Manual

track timers

The Timer function features three different types of timers. Timers are provided for measuring Lap, Interval, and Countdown and
Count-Up timers. These three timers can also be used simultaneously. In addition, a high degree of freedom and convenience
is provided by the ability to assign each of the timers to a switch to perform simultaneous or independent operation. Separate
tones can be assigned to each of the timers, making it easy to distinguish between them during simultaneous operation. The
audible signal provided by the Tone is complemented by a Vibrator*, which can be set to operate either in concert with the tone,
or simultaneously. The operational status of the timers is also displayed in the Information Window.
The timer status appears in the Information Window.
The timers appear in the timer display area in the order
FUNC1>FUNC2>FUNC3, as set using the Key Assign
function. See page 50 for more information. In the example
at right, LAP appears as assigned to FUNC1.
*See page 46 for more information.
[ LAP ] LAP TIMEr
The Lap Timer function allows you to measure and record times for up to 99 laps. Featured are a Pre-Alarm (PRE-ALM), the
ability to set a (GOAL) time, a real-time display of the best lap time (BEST), average lap time (AVE), and total (TOTAL) laps.
Turning On the Lap Timer (Count-up Timer)
1) Press the Function key to highlight the TIMER menu. [LAP] will be
active in the Programming Window and the cursor will default to OFF.
2) Press INC/+ or DEC/- keys to turn the Lap Timer ON.
00' (Minutes) 00" (Seconds) 00 (Milliseconds).
GOAL Time Setting
1) Press the ENTER key to move the cursor to GOAL in the Programming
Window, then press INC/+ or DEC/- keys to set the desired GOAL value.
TIMER LAP GOAL setting range is 10 seconds to 60 minutes in 10 second
increments. The default setting is 60 minutes.
Pre-Alarm Setting
1) Press the ENTER key to move the cursor to PRE-ALM in the Programming
Window, then press INC/+ or DEC/- keys to set the desired PRE-ALM
value.
TIMER LAP PRE-ALM setting range is OFF and 1 second to 20 seconds.
The default setting is 5 seconds.
The Pre-Alarm sounds the programmed number of seconds prior to
the GOAL Time.
Function Page 2 (TIMER)
Pointer Revolves
While Timer is
Running
Timer Display
Page 34
FUNC1
FUNC2
FUNC3