Sanwa M11X Operating Manual page 49

audio signal sound
Pre-Alarm Tone Setting
1) Press the ENTER key to move the cursor to the left-side PRE-ALM S10
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the first half S10 setting.
2) Press the ENTER key to move the cursor to the right-side PRE-ALM
S10 setting, then press the INC/+ or DEC/- keys to adjust the desired
Tonal value for the second half S10 setting.
SIGNL PRE-ALM setting range is MUTE to S10. The default setting is S10. When changes are made to the Tonal settings, the
selected Tone is sounded. The Pre-Alarm Tone setting affects the Lap Timer.
Pre-Alarm Countdown Tone Setting
1) Press the ENTER key to move the cursor to the left-side DOWN S05
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the first half S05 setting.
2) Press the ENTER key to move the cursor to the right-side DOWN S05
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the second half S05 setting.
SIGNL DOWN setting range is MUTE to S10. The default setting is S05. When changes are made to the Tonal settings, the
selected Tone is sounded. The DOWN Tone setting affects the Countdown Timer.
Interval Timer Minutes Tone Setting
1) Press the ENTER key to move the cursor to the left-side INT-T1 S10
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the first half S10 setting.
2) Press the ENTER key to move the cursor to the right-side INT-T1 S10
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the second half S10 setting.
SIGNL INT-T1 setting range is MUTE to S10. The default setting is S10. When changes are made to the Tonal settings, the
selected Tone is sounded. The INT-T1 Tone setting affects the Minutes portion of the Interval Timer.
Interval Timer Seconds Tone Setting
1) Press the ENTER key to move the cursor to the left-side INT-T2 S08
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the first half S08 setting.
2) Press the ENTER key to move the cursor to the right-side INT-T2 S08
setting, then press the INC/+ or DEC/- keys to adjust the desired Tonal
value for the second half S08 setting.
SIGNL INT-T2 setting range is MUTE to S10. The default setting is S08. When changes are made to the Tonal settings, the
selected Tone is sounded. The INT-T2 Tone setting affects the Seconds portion of the Interval Timer.
Page 49