Servo Reversing; Track Timers - Sanwa M11X Operating Manual

track timers

Setting the Countdown Timer
1) Press the ENTER key to move the cursor to 00', then press INC/+ or
DEC/- keys to set the desired Countdown Time in Minutes.
2) Press the ENTER key to move the cursor to 00", then press INC/+ or
DEC/- keys to set the desired Countdown Time in Seconds.
3) Press the ENTER key to move the cursor to 00, then press INC/+ or
DEC/- keys to set the desired Countdown Time in Milliseconds.
TIIMER DOWN setting range is 0 minutes to 99 minutes in 1 minute increments, 0 seconds to 59 seconds in 1 second
increments, and 0 milliseconds to 90 milliseconds in 10 millisecond intervals. The default setting is 00' minutes, 00" seconds,
and 00 milliseconds.
Starting the Countdown Timer
1) In the default configuration, the Countdown Timer Switch is assigned to Sw 3. To start the Countdown Timer, press the
Countdown Timer Switch. The Countdown Timer will start counting down from the preset time. When the Countdown Timer
is within 10 seconds of zero, an alarm will sound at 1 second intervals. Once zero is reached, a longer alarm will sound
and the Countdown timer will begin counting up. An alarm will then sound at 1 minute intervals during the count up phase.
Pressing the Countdown Timer Switch a second time will reset the Countdown Timer and it will begin counting down again.
The Interval Timer Switch can be assigned to another switch, using the Key Assign function. See page 50 for more
information.
Stopping the Countdown Timer
1) The Countdown Timer can be stopped using two different methods:
A) By pressing and holding the Countdown Timer Switch for 3 seconds.
B) By pressing the INC/+ and DEC/- keys at the same time.
When the Countdown Timer stopped, the Countdown Timer function
is automatically turned OFF. To turn the Countdown Timer function
back ON, see Turning On the Countdown Timer on the previous page.

servo reversing

The Servo Reversing function electronically switches the direction of servo travel. For example, if you move the steering wheel
to the right, and the steering servo moves to the left, you can use the Servo Reversing function to make the steering servo move
to the left.
1) Press the Function key to highlight the REV menu. [ST] will be active
in the Programming Window.
2) Press INC/+ or DEC/- keys to set the direction of servo travel.
REV setting range is NOR/REV. The default setting is NOR.
3) Adjust the remaining Servo Reversing settings using the same
techniques. If the transmitter is set to 2CH Mode, only ST and TH will
be shown in the Programming Window.
Function Page 2 (REv)
Page 37